|
Post by John "Rockin" Reed on Mar 3, 2009 23:44:20 GMT -5
I had the TCS remote hub in my PB footprint Litex and it worked fine for it. However, when I put it back in the Craftmade, it doesn't seem to operate. If you look closely in the bottom pic, there was a thin wire that was cut in 2 that supposedly connected to the main plug that attaches to the remote hub. I was able to reconnect it as depicted in the pic. What could be the problem?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 6, 2009 4:40:53 GMT -5
Does it still work fine on the Litex? Is this a remote receiver? Do you have a matching 3 speed set?
|
|
|
Post by John "Rockin" Reed on Mar 6, 2009 11:19:07 GMT -5
Does it still work fine on the Litex? Is this a remote receiver? Do you have a matching 3 speed set? I'll try it again on the Litex, and I'll ge ta replacement TCS unit on Ebay for the Craftmade. Do you think a new TCS receiver is the way to go for the Presidential I?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 6, 2009 21:19:10 GMT -5
First try it back on the Litex and see if it still works. The question is, is the kit fried, or did part of it short in order to operate the Litex, or is something else wrong with the Craftmade. Could also be a finnicky connector.
I hate remote fans.
|
|
|
Post by John "Rockin" Reed on Mar 16, 2009 23:15:16 GMT -5
i just tested it out and it worked on both fans
woo hoo!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 26, 2009 1:29:01 GMT -5
Problem solved?
|
|
|
Post by John "Rockin" Reed on Mar 26, 2009 12:13:52 GMT -5
Yes, I would say
|
|