|
how
Nov 23, 2008 0:59:20 GMT -5
Post by Troy on Nov 23, 2008 0:59:20 GMT -5
in the hell do take a swich housing off a casablanca panama it does not unscrew so how do you do it.
|
|
|
how
Nov 23, 2008 2:10:53 GMT -5
Post by Andrew G. on Nov 23, 2008 2:10:53 GMT -5
This is a very good question, perhaps Dan should inform us as to how this is done.. properly.
|
|
|
how
Nov 23, 2008 9:12:32 GMT -5
Post by Cole S. on Nov 23, 2008 9:12:32 GMT -5
I don't know exactly how to do it, but I know you have to go to the top of the motor, with the wires removed from the shaft, and drive out the whole shaft with the switch housing attached.
|
|
|
how
Nov 24, 2008 15:45:26 GMT -5
Post by Ben C. on Nov 24, 2008 15:45:26 GMT -5
Use a hammer!!!
j/k, bad advice.
|
|
|
how
Nov 24, 2008 20:24:59 GMT -5
Post by Cole S. on Nov 24, 2008 20:24:59 GMT -5
I believe there was a video somewhere at one point that showed how to do what I described. I tried You Tube but couldn't find anything.
|
|
Deleted
Deleted Member
Posts: 0
|
how
Nov 24, 2008 22:45:15 GMT -5
Post by Deleted on Nov 24, 2008 22:45:15 GMT -5
|
|
|
how
Dec 13, 2008 0:28:00 GMT -5
Post by Cole S. on Dec 13, 2008 0:28:00 GMT -5
|
|