|
Post by Trevor on Oct 26, 2006 22:35:57 GMT -5
Got my fan in the mail and upon opening the nose I found the blue light kit wire, but no white to be found. The circuit board in the nose says Light Drive Module and looks to have one connection free, as if i a plug or something was there and is now gone. I want to eventually equip this fine zephyr with a light kit, but whats going on? Whats the light drive module exactly?
Trevor
|
|
|
Post by Tyler on Oct 27, 2006 3:05:39 GMT -5
Trevor, is there a connector on that little circuit board?
The Fan Portion of the Inteli-Touch is up in the fan housing itself.
The LDM is seperate, and is in the switch housing, if the board is not there, there is a 4 wire connector. Otherwise i dont know.
Take Care, Tyler
|
|
|
Post by Trevor S on Oct 27, 2006 6:43:54 GMT -5
There are 2 boards present. The large one on the side of the motor has already been replaced by me. (old one fried) The small one in the nose does have 4 some wires which are unremovable permanent and hooked to the board, but there is an open plug end as if some type of PC connection goes there. Is part of the module missing? Trevor
|
|
|
Post by TrevorS on Oct 27, 2006 6:51:58 GMT -5
Upon another check, the open plug-connecter has LT 1 and LT 2 under the plug. The wires plugged in are not permanent, but hooked up to the plug next to LT 1 and 2. They share the same plug, but have specific spots to hook up
|
|