|
|
Post by Andrew G. on Nov 28, 2004 15:32:03 GMT -5
You all have probably heard that I recently acquired an ancient C-17 original motor. Anyway, before I can finish the restoration process, I need to get the motor working right. The speed coil is shot so the motor only works on one speed. The porcelin switch is cracked and broken, and the thrust bearing is badly worn (probably because of a lack of oil). Aside from blades and brackets, I need a coil, a switch and a new bearing to get it to work correctly.
|
|
|
|
Post by CEILINGFANWIZ on Nov 28, 2004 23:02:39 GMT -5
i have some spare used bearings, but from what i understand the shaft sizes are different between the older oruiginals and the more modern ones. i have a spare leviton lever pull switch, but i was plannign on keeping that fo rmyself. i will be on the lookout for the switch and the bearings
i will also get the number for Texas Ceiling Fans for you... they have a ton of old fan parts, also you might want to check with don taussig, in florida?
......brian
|
|
|
|
Post by CEILINGFANWIZ on Nov 28, 2004 23:07:01 GMT -5
also that speed coil may not be gone, if it's just shorted it probabyl can be restored to service by a local motor shop, and if you want the fan itself to a be a reliable piece, you may want to have the winding dipped in insulating varnish (not much $$$ they can do the same fo rthe coil or the coil may have to be re-wound, but if you are to find a veyr good cond. coil it will run you more than if you have yours re-insulated or to have it rewound, (p.s. it doesnt take long at all for thse automatic winders to get the exact number of turns and to make the coil itself then place it back in there....
hope this helps,brian
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 30, 2004 17:54:17 GMT -5
I need a coil, a switch and a new bearing to get it to work correctly. This wouldnt be the place to find those parts, Adrian might have an idea of some sources. Speed coils can be rewound relatively easy. |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 30, 2004 17:55:18 GMT -5
i have a spare leviton lever pull switch, but i was plannign on keeping that fo rmyself. I believe he's talking about the rotary porcelin switch that sits, facing downward, in the bottom of the switch housing. |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 30, 2004 17:56:39 GMT -5
you may want to have the winding dipped in insulating varnish You can spray it on yourself. Get the red stuff, Grainger has it for $5 a can. I believe it also comes in clear. |
|
|
|
Post by CEILINGFANWIZ on Nov 30, 2004 22:13:56 GMT -5
no, it's better to buy a quart or two, thin it a bit, and then dip it and then put the lid back on the can then leave it for about 24 hours....
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 30, 2004 22:24:36 GMT -5
no, it's better to buy a quart or two, thin it a bit, and then dip it and then put the lid back on the can then leave it for about 24 hours.... All of the motor shops and experts I know have always recommended the spray, I've always had good results with it. The dipping may be just as good if not better, but it's a lot more trouble. |
|
