flash
New Member
Posts: 2 
|
Post by flash on Nov 3, 2013 14:47:08 GMT -5
I need to repair a circuit board for my casa Blanca Panama 5 ceiling fan. Some components failed and the end of the circuit board was fried. I have a fair amount of electronic experience so feel confident I can fix or create a new one. What I really need is the schematic or even a picture of the traces on thr back. Mine is turned to carbon on the end where the resistors are.
Help greatly apreciated,
Thanks
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 3, 2013 22:15:21 GMT -5
How is the fan controlled?
|
|
flash
New Member
Posts: 2
|
Post by flash on Nov 4, 2013 14:59:15 GMT -5
The fan is simply turned on/off at the wall switch but it does have a pot on the side of the unit to set the speed plus a switch to change the direction. I have not taken the motor unit apart but I am guessing there is some sort of Triac, etc. to control the A/C to the motor. Not sure if that could be damaged too.
|
|
|
|
Post by Andrew G. on Nov 4, 2013 15:31:18 GMT -5
Ahhh, Slumber Quiet... THIS thread may be able to help you. |
|
|
|
Post by Adam D. on Nov 4, 2013 16:07:28 GMT -5
You could always retrace the board with wire seeing how the foil in the circuit board is probably shorted and burned up in areas... Let me see if I have a pic of the one I'm looking into now.. Or you can always try this guy: ceilingfanpartsonline.com/Last I talked with him he said he had some generic Slumber Quiet boards still lying around.. |
|
|
|
Post by Adam D. on Nov 4, 2013 16:15:40 GMT -5
Here's a pic of the back of the board of the Zephyr I have working..  |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 4, 2013 23:30:41 GMT -5
Best thing to do is convert it to three speed, or just use a wall control. Slumber Quiet boards are prone to failure even if you repair/replace them.
Most Casablanca Repair Centers stock/stocked the three speed conversion kits.
|
|
|
|
Post by gducote on Jul 7, 2021 15:40:52 GMT -5
I need to repair a circuit board for my casa Blanca Panama 5 ceiling fan. Some components failed and the end of the circuit board was fried. I have a fair amount of electronic experience so feel confident I can fix or create a new one. What I really need is the schematic or even a picture of the traces on thr back. Mine is turned to carbon on the end where the resistors are. Help greatly apreciated, Thanks |
|
|
|
Post by gducote on Jul 7, 2021 15:43:54 GMT -5
Did you ever get a schematic of the circuit board? I have pulled out the circuit board of the Casablanca fan and found a resistor burned out and unreadable. There are five resistors and I presume this one is CR5 although the board is so scorched as to be unable to read printed writing.
|
|
|
|
Post by vanhalen5150 on Jul 8, 2021 22:50:01 GMT -5
What type of board do you have? I.E. What control system?
|
|
